ivqyfn3768 / How-to-change-the-lamp-if-it-leads-nowhere

Change the lighting is usually a simple question, solar ground screw to eliminate the old and new wiring circuit in the same place. It is usually not even need you to do any control over the light switch. Common complication is the position of the light. Ceiling lights, from the top of a ladder, which means that tracking what you need per trip with you - be careful, once you have your work. 1 Turn off the power to the existing lighting in the house fuse box. 2 set of lamps ladder, climb up, you take your screwdriver. Remove the screws holding the lamp on the ceiling. Lower the enough untwisting on the line cap, disconnect the wires behind it. Pull the light. You should leave an open electrical boxes, three exposed end of the line: black, steel plate ground anchor white and bare. 3Looking for a new lamp mounting bracket, together with its screw, and their ladder. Electrical box mounting bracket with screws. 4Green grounding screw on the mounting bracket of the bare copper ground wire connection. The grounding screw is tightened. 5 brought the light fixtures and electrical boxes held near the ladder. Line cap, white line white line from the fixture from the electrical box connection. Do the same two black lines. 6 Lift the lighting electrical boxes, push restricted area two-wire connection. Fixture mounting bracket to the screw. 7Turn power on the fuse box ground screw.www.ground-screw.com